Installing retrofit can lights

How to replace recessed lighting with led the diy how to install led retrofit can light kit how to install led recessed lighting retrofit trim for 5 or 6 halo ra 5 and 6 in white integrated led recessed light adjule. Prev Article. Next Article.

Related Articles. Tectum ceiling tiles continental armstrong ceilings common 24 in x …. Shades for pendant lights pendant light fixture warm glass globes …. About The Author Shelly Lighting. This website uses cookies to improve your experience.

The reviews for these bulbs aren't that great on the Home Depot site but I've had them for about a year now and haven't had any issues with them.

They certainly don't dim as much as regular incandescent or halogen bulbs and you must use a CFL dimmer with them, but other than that they've worked fine for me. Lousy pics from my phone, but yes they do dim:.

I went with a reflector trim because I wanted the light pattern to be slightly more focused like a spotlight. Halo P is the part number. Lots of it. I used the Southwire ft. You'll inevitably need to drill through a ceiling joist at one point or another. You'll need these to repair the numerous holes you're about to punch in your ceiling. My ceiling has a knockdown texture. You won't need this if yours doesn't. Privacy Policy. Electric power for recessed lights can come from either an existing source or from an electrical circuit installed just for this project.

The cost, speed, and ease of installation all hinge on the availability of electricity at the start of the run of recessed lights. Purchase old-work or remodel recessed lights. These lights do not need to be secured to ceiling joists. Instead, they attach directly to the ceiling drywall. IC-rated recessed lights are appropriate for ceilings that contain insulation as they can be covered over with insulation.

Non-IC-rated recessed lights must have clearance above and around the light housing in the ceiling area. Installing your own recessed lights will be much less expensive than hiring an electrician. Most communities will require a permit to enlarge, build, or alter residential lighting systems, activities that cover recessed lighting installation. Check with your local permit office to see if you need one.

Turn off the circuit breaker servicing the electrical cable you are working on. If the circuit has not yet been connected, wait until the recessed lights have been installed to make this final connection. Test circuits with a voltage tester. When working above ceilings, wear breathing protection.

Be careful of roofing nails protruding from the roof. Walk only on rafters or joists to avoid falling through the ceiling drywall. Use a piece of plywood to stand or sit on when working in the attic. Use the paper template supplied by most light manufacturers to draw a circle for the hole. Put on your eye protection. Use a jab saw to carefully cut along the line. For cutting more than just a couple of holes, use a hole saw attached to the end of a drill, as this goes faster.

Rough-in the supply wire to the recessed light. If the wire will be coming from another recessed light, open the previous light's junction box and attach the wire.